Why Won’t My Aiper Scuba S1 Turn Off?
Exact model: Aiper Scuba S1
Safety: Disconnect the relevant power source and isolate moving, hot or pressurized components before service.
A.
Start with the accessible checks
What this suggests: A robot apparently refusing to turn off may actually be completing a required shutdown sequence, have a stuck physical Power switch or a controller fault.
What to do
- Take it out of the pool into a dry safe area and use the power-button hold specified by the exact Scuba S1 manual (commonly around two seconds).
- Dry the button area and remove external debris without penetrating the sealed electrical body.
Still not fixed? Continue to the next check.
↑ Back to the repair pathsB.
If the problem remains after the first checks
What to do
- Let the unit stop its motor cycle before trying again.
- Do not substitute internet advice to short battery contacts or open the wet sealed casing.
- A non-responsive key with a continually active motor needs qualified sealed-appliance service.
Confirm the repair
The switch reliably turns the machine off and it remains off before charging/storage.