Why Does My Genmitsu 3018-PROVer V2 Stop Mid-Job in Candle?
Exact model: Genmitsu 3018-PROVer V2
Safety: Remove cutting tools and disconnect both 24 V and USB before moving connectors or servicing axes.
A.
Start with the accessible checks
What this suggests: Separate Candle/USB disconnection from controller power reset, an interrupted G-code file and a cutting load that stalls an axis.
What to do
- Save the full console output and note whether the COM port disappears.
- Secure the 24 V supply and power connector, inspect the USB data lead and route it away from spindle/motor cables.
- Reduce excessive depth of cut and confirm the spindle can sustain the programmed feed.
Still not fixed? Continue to the next check.
↑ Back to the repair pathsB.
If the problem remains after the first checks
What to do
- If a repeated stop occurs at the identical G-code line, examine the command and controller response rather than replacing the motor.
- Check emergency-stop and limit inputs for intermittent activation.
- Suspect controller hardware only after the independent power and host paths are stable.
Confirm the repair
A representative complete job runs without controller restart, lost position or spontaneous serial disconnect. Never continue an unattended laser/spindle motion test.