Why Is My HTVRONT Auto Heat Press Scorching Transfers or Fabric?
Exact model: HTVRONT Auto Heat Press Gen 1 (HPM15)
Safety: Unplug and allow the platen to cool before inspecting; never open a live heating enclosure.
A.
Start with the accessible checks
What this suggests: Burning is usually a material/time/temperature mismatch, raised contact point or genuine temperature overshoot.
What to do
- Check the fabric and transfer maker's permitted temperature and peel process, then test scrap at the lowest effective temperature and shortest supported dwell.
- Do not run a sublimation-temperature preset on low-melt synthetics.
- Flatten the press area, move buttons and seams away from the platen and use an approved heat-resistant cover.
Still not fixed? Continue to the next check.
↑ Back to the repair pathsB.
If the problem remains after the first checks
What this suggests: Already melted fibers cannot be restored by additional heating.
What to do
- If the display's measured temperature clearly climbs beyond the setpoint (one reported unit reached about 220°C at a 180°C setting), stop use and have the HPM15 temperature-control circuit professionally diagnosed; shortening time cannot make runaway heating safe.
Confirm the repair
A scrap transfer bonds without shiny scorch, melting or color change, and actual temperature stays under control throughout the cycle.