How Do I Fix Error E2 on My VEVOR CIM-360T Ice Maker?
Exact model: VEVOR CIM-360T
Safety: Disconnect the relevant power source and isolate moving, hot or pressurized components before service.
A.
Start with the accessible checks
What this suggests: E2 is the CIM-360T temperature-probe short-circuit category.
What to do
- Stop and unplug; inspect the sensor loom at bends and its control-board connector for pinched insulation, moisture and shorted conductors.
Still not fixed? Continue to the next check.
↑ Back to the repair pathsB.
If the problem remains after the first checks
What this suggests: It is not interchangeable with the E1 open-circuit diagnosis.
What to do
- Restore a damaged cable or terminal using the correct insulated service component, and replace a verified shorted temperature probe with the model-matched item.
- Do not bridge or substitute fixed resistors to conceal the alarm; note that public documents lack a validated owner ohm chart.
Confirm the repair
E2 clears, temperature indication behaves normally and the unit passes successive controlled ice and harvest cycles.