Why Is My Dreame D10 Plus Gen 2 Leaving the Floor Too Wet?
Exact model: Dreame D10 Plus Gen 2
Safety: Disconnect the relevant power source and isolate moving, hot or pressurized components before service.
A.
Start with the accessible checks
What this suggests: Excessive mop wetness is usually a high app flow setting, an over-soaked cloth or a tank valve/seal leaking when flow should stop.
What to do
- Set the D10 Plus Gen 2 water output to the lowest suitable mode, wring out the washable pad to a normal starting moisture level and check that the tank seats with its outlet seal intact.
Still not fixed? Continue to the next check.
↑ Back to the repair pathsB.
If the problem remains after the first checks
What to do
- Clear grit from the outlet and inspect whether the tank drips with the module removed according to the user instructions.
- Replace a confirmed cracked/leaking tank or faulty matching outlet part rather than sealing an electrical robot with adhesive.
Confirm the repair
The floor dries normally with no puddles and the tank does not keep dripping when the mop function is off.